STM32F215VG datasheet(27/175 Pages) STMICROELECTRONICS

27 / 175 page

DocID17050 Rev 9

27/175

STM32F21xxx

Functional overview

174

and the HSE crystal oscillators are disabled. The voltage regulator can also be put

either in normal or in low-power mode.

The device can be woken up from the Stop mode by any of the EXTI line. The EXTI line

source can be one of the 16 external lines, the PVD output, the RTC alarm / wakeup /

tamper / time stamp events, the USB OTG FS/HS wakeup or the Ethernet wakeup.

•

Standby mode

The Standby mode is used to achieve the lowest power consumption. The internal

voltage regulator is switched off so that the entire 1.2 V domain is powered off. The

PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering

Standby mode, the SRAM and register contents are lost except for registers in the

backup domain and the backup SRAM when selected.

The device exits the Standby mode when an external reset (NRST pin), an IWDG reset,

a rising edge on the WKUP pin, or an RTC alarm / wakeup / tamper /time stamp event

occurs.

Note:

The RTC, the IWDG, and the corresponding clock sources are not stopped when the device

enters the Stop or Standby mode.

3.19

VBAT operation

The VBAT pin allows to power the device VBAT domain from an external battery or an

external supercapacitor.

VBAT operation is activated when VDD is not present.

The VBAT pin supplies the RTC, the backup registers and the backup SRAM.

Note:

When the microcontroller is supplied from VBAT, external interrupts and RTC alarm/events

do not exit it from VBAT operation.

3.20

Timers and watchdogs

The STM32F21x devices include two advanced-control timers, eight general-purpose

timers, two basic timers and two watchdog timers.

All timer counters can be frozen in debug mode.

Table 4 compares the features of the advanced-control, general-purpose and basic timers.

Table 4. Timer feature comparison

Timer type Timer

Counter

resolution

Counter

type

Prescaler

factor

DMA

request

generation

Capture/

compare

channels

Complementary

output

Max

interface

clock

Max

timer

clock

Advanced-

control

TIM1,

TIM8

16-bit

Up,

Down,

Up/down

Any integer

between 1

and 65536

Yes

60 MHz

120

MHz

STM32F215VG bảng dữ liệu(PDF) 27 Page - STMicroelectronics

STM32F215VG bảng dữ liệu(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL