1/13/98

Am29F200A Known Good Die

7

SUP P LEM E NT

PHYSICAL SPECIFICATIONS

Die dimensions . . . . . . . . . . . . . . 191 mils x 174 mils

. . . . . . . . . . . . . . . . . . . . . . . . . . . 4.85 mm x 4.42 mm

Die Thickness . . . . . . . . . . . . . . . . . . . . . . . . ~20 mils

Bond Pad Size . . . . . . . . . . . . . . 4.55 mils x 4.55 mils

. . . . . . . . . . . . . . . . . . . . . . . . . . 115.6

µm x 115.6 µm

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13,363

Pads Per Die . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42

Bond Pad Metalization . . . . . . . . . . . . . . . . . . Al/Cu/Si

Die Backside . . . . . . . . . . . . . . . . . . . . . . . . No metal,

may be grounded (optional)

Passivation. . . . . . . . . . . . . . . . . . Nitride/SOG/Nitride

DC OPERATING CONDITIONS

Operating Temperature

Commercial . . . . . . . . . . . . . . . . . . . 0

°C to +70°C

Industrial . . . . . . . . . . . . . . . . . . . –40

°C to +85°C

Extended . . . . . . . . . . . . . . . . . . –55

°C to +125°C

MANUFACTURING INFORMATION

Manufacturing . . . . . . . . . . . . . . . . . . . . . . . . . . FASL

Test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SDC

Manufacturing ID (Top Boot) . . . . . . . . . . . . 98483AK

(Bottom Boot) . . . . . . . .98483ABK

Preparation for Shipment . . . . . . . . Penang, Malaysia

Fabrication Process . . . . . . . . . . . . . . . . . . . CS29AF

Die Revision . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

SPECIAL HANDLING INSTRUCTIONS

Processing

Do not expose KGD products to ultraviolet light or

process them at temperatures greater than 250

°C.

Failure to adhere to these handling instructions will

result in irreparable damage to the devices. For best

yield, AMD recommends assembly in a Class 10K

clean room with 30% to 60% relative humidity.

Storage

Store at a maximum temperature of 30

°C in a nitrogen-

purged cabinet or vacuum-sealed bag. Observe all

standard ESD handling procedures.