MP4460 – 2.5A, 4MHz, 36V STEP-DOWN CONVERTER

MP4460 Rev. 1.02

www.MonolithicPower.com

4

12/24/2013

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2013 MPS. All Rights Reserved.

PIN FUNCTIONS

Pin #

Name Description

1, 2

SW

Switch Node. This is the output from the high-side switch. A low forward drop Schottky diode to

ground is required. The diode must be close to the SW pins to reduce switching spikes.

3

EN

Enable Input. Pulling this pin below the specified threshold shuts the chip down. Pulling it up

above the specified threshold or leaving it floating enables the chip.

4

COMP

Compensation. This node is the output of the error amplifier. Control loop frequency

compensation is applied to this pin.

5

FB

Feedback. This is the input to the error amplifier. The output voltage is set by an resistive

+0.8V reference.

6

GND

Ground. It should be connected as close as possible to the output capacitor to shorten the high

current switch paths.

7

FREQ

Switching Frequency Program Input. Connect a resistor from this pin to ground to set the

switching frequency.

8, 9

VIN

Input Supply. This supplies power to all the internal control circuitry, both BS regulators and the

high-side switch. A decoupling capacitor to ground must be placed close to this pin to minimize

switching spikes.

10

BST

Bootstrap. This is the positive power supply for the internal floating high-side MOSFET driver.

Connect a bypass capacitor between this pin and SW pin.