TS52002 datasheet(4/14 Pages) ETC2

4 / 14 page

- 4 -

TS52002

Version 1.2

Specifications subject to change

WWW.TRIUNESYSTEMS.COM

ABSOLUTE MAXIMUM RATINGS

Over operating free–air temperature range unless otherwise noted(1,2,3)

Parameter

Range

Unit

VIN, EN, nFLT, SCL, SDA, VBAT, VSENSE

-0.3 to 8

-1 to 8.8

VDD

-0.3 to 3.6

Operating Junction Temperature Range, TJ

-40 to 125

C

Storage Temperature Range, TSTG

-65 to 150

C

Electrostatic Discharge – Human Body Model

±2k

Electrostatic Discharge – Machine Model

+/-200

Lead Temperature (soldering, 10 seconds)

260

C

(1) Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and functional

operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not implied. Exposure to

absolute–maximum–rated conditions for extended periods may affect device reliability.

(2) All voltage values are with respect to network ground terminal.

(3) ESD testing is performed according to the respective JESD22 JEDEC standard.

THERMAL CHARACTERISTICS

Symbol

Parameter

Value

Unit

JA

Thermal Resistance Junction to Air (Note 1)

°C/W

Note 1: Assumes 4x4 QFN-16 in 1 in2 area of 2 oz copper and 25C ambient temperature.

RECOMMENDED OPERATING CONDITIONS

Symbol

Parameter

Min

Typ

Max

Unit

VIN

Photovoltaic Input Operating Voltage

3.2

5.3

7.2

RSENSE

Sense Resistor

m

LOUT

Output Filter Inductor Typical Value (Note 1)

4.7

COUT

Output Filter Capacitor Typical Value (Note 2)

4.7

COUT-ESR

Output Filter Capacitor ESR

100

m

CIN

Input Supply Bypass Capacitor Typical Value (Note 3)

3.3

CVDD

VDD Supply Bypass Capacitor Value (Note 2)

100

130

Operating Free Air Temperature

-40

C

Operating Junction Temperature

-40

125

C

Note 1: For best performance, an inductor with a saturation current rating higher than the maximum VBAT load requirement plus the inductor current ripple.

Note 2: For best performance, a low ESR ceramic capacitor should be used.

Note 3: For best performance, a low ESR ceramic capacitor should be used. If CIN is not a low ESR ceramic capacitor, a 0.1uF ceramic capacitor should be

added in parallel to CIN.

TS52002 bảng dữ liệu(PDF) 4 Page - List of Unclassifed Manufacturers

TS52002 bảng dữ liệu(HTML) 4 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

bảng dữ liệu tải về

Link URL