ADP1706ARDZ-1.3-R7 datasheet(4/20 Pages) AD

4 / 20 page

ADP1706/ADP1707/ADP1708

Rev. 0 | Page 4 of 20

Parameter

Symbol

Test Conditions

Min

Typ

Max

Unit

OUTPUT NOISE

OUTNOISE

10 Hz to 100 kHz, VOUT = 0.75 V

125

μV rms

10 Hz to 100 kHz, VOUT = 3.3 V

450

μV rms

POWER SUPPLY REJECTION RATIO

PSRR

1 kHz, VOUT = 0.75 V

1 kHz, VOUT = 3.3 V

1 Accuracy when OUT is connected directly to ADJ. When OUT voltage is set by external feedback resistors, absolute accuracy in adjust mode depends on the tolerances

of resistors used.

2 Based on an end-point calculation using 10 mA and 1 A loads. See Figure 11 for typical load regulation performance for loads less than 10 mA.

3 Dropout voltage is defined as the input-to-output voltage differential when the input voltage is set to the nominal output voltage. This applies only for output

voltages above 2.5 V.

4 Start-up time is defined as the time between the rising edge of EN to OUT being at 95% of its nominal value.

5 Current limit threshold is defined as the current at which the output voltage drops to 90% of the specified typical value. For example, the current limit for a 1.0 V

output voltage is defined as the current that causes the output voltage to drop to 90% of 1.0 V, or 0.9 V.

ADP1706ARDZ-1.3-R7 bảng dữ liệu(PDF) 4 Page - Analog Devices

ADP1706ARDZ-1.3-R7 bảng dữ liệu(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

bảng dữ liệu tải về

Link URL