TLP714F

1

Photocouplers GaAℓAs Infrared LED & Photo IC

TLP714F

TLP714F

TLP714F

TLP714F

1.

1.

1.

1. Applications

Applications

Applications

Applications

•

Intelligent Power Module Signal Isolation

•

Factory Automation (FA)

•

Transistor Inverters

2.

2.

2.

2. General

General

General

General

The TLP714F is a photocoupler in a 6-pin SDIP package that consists of a GaAℓAs infrared light-emitting diode

(LED) optically coupled to an integrated high-gain, high-speed photodetector IC chip. It provides guaranteed

performance and specifications at temperatures up to 125.

The TLP714F is physically smaller than the one in an 8-pin DIP package and compliant with international safety

standards for reinforced insulation. It thus provides a smaller footprint solution for applications that require

safety standard certification. An internal noise shield provides a guaranteed commonmode transient immunity

of 20 kV/µs. The TLP714F guarantees minimum and maximum of propagation delay time, pulse width distortion.

Therefore it is suitable for isolation interface between IPM and control IC circuits in motor control application.

Leads of the TLP714F is bend to satisfy 8 mm PC board spacing requirements. Absolute maximum ratings and

electrical characteristics are the same as in the TLP714.

3.

3.

3.

3. Features

Features

Features

Features

(1)

Inverter logic type (open collector output)

(2)

Package: SDIP6

(3)

Operating temperature: -40 to 125

(4)

Supply voltage: -0.5 to 30 V

(5)

Threshold input current: 5.0 mA (max)

(6)

Supply current: 1.3 mA (max)

(7)

(8)

(9)

Common-mode transient immunity: ±20 kV/µs (min)

(10) Isolation voltage: 5000 Vrms (min)

(11) Safety standards

UL-approved: UL1577 File No.E67349

cUL-approved: CSA Component Acceptance Service No.5A, File No.E67349

VDE-approved: Option (D4) EN60747-5-2 (Note)

Note: When an EN60747-5-2 approved type is needed, please designate the Option (D4).

4.

4.

4.

4. Packaging and Pin Configuration

Packaging and Pin Configuration

Packaging and Pin Configuration

Packaging and Pin Configuration

11-5J101S

1: Anode

2: N.C.

3: Cathode

4: GND

2012-09-16

Rev.3.0