STM32F102X8 datasheet(49/80 Pages) STMICROELECTRONICS

49 / 80 page

DocID15056 Rev 5

49/80

STM32F102x8, STM32F102xB

Electrical characteristics

5.3.10

EMC characteristics

Susceptibility tests are performed on a sample basis during device characterization.

Functional EMS (Electromagnetic susceptibility)

While a simple application is executed on the device (toggling 2 LEDs through I/O ports).

the device is stressed by two electromagnetic events until a failure occurs. The failure is

indicated by the LEDs:

•

Electrostatic discharge (ESD) (positive and negative) is applied to all device pins until

a functional disturbance occurs. This test is compliant with the IEC 61000-4-2 standard.

•

FTB: A Burst of Fast Transient voltage (positive and negative) is applied to VDD and

VSS through a 100 pF capacitor, until a functional disturbance occurs. This test is

compliant with the IEC 61000-4-4 standard.

A device reset allows normal operations to be resumed.

The test results are given in Table 31. They are based on the EMS levels and classes

defined in application note AN1709.

Designing hardened software to avoid noise problems

EMC characterization and optimization are performed at component level with a typical

application environment and simplified MCU software. It should be noted that good EMC

performance is highly dependent on the user application and the software in particular.

Therefore it is recommended that the user applies EMC software optimization and pre

qualification tests in relation with the EMC level requested for his application.

Software recommendations: the software flowchart must include the management of

runaway conditions such as:

•

Corrupted program counter

•

Unexpected reset

•

Critical Data corruption (control registers, etc.)

Prequalification trials

Most of the common failures (unexpected reset and program counter corruption) can be

reproduced by manually forcing a low state on the NRST pin or the Oscillator pins for 1

second. To complete these trials, ESD stress can be applied directly on the device, over the

range of specification values. When unexpected behavior is detected, the software can be

hardened to prevent unrecoverable errors occurring (see application note AN1015).

Table 29. EMS characteristics

Symbol

Parameter

Conditions

Level/Class

VFESD

Voltage limits to be applied on any I/O pin to

induce a functional disturbance

VDD = 3.3 V, TA = +25 °C,

fHCLK= 48 MHz

conforms to IEC 61000-4-2

VEFTB

Fast transient voltage burst limits to be

applied through 100 pF on VDD and VSS pins

to induce a functional disturbance

VDD = 3.3 V, TA = +25 °C,

fHCLK = 48 MHz

conforms to IEC 61000-4-4

STM32F102X8 bảng dữ liệu(PDF) 49 Page - STMicroelectronics

STM32F102X8 bảng dữ liệu(HTML) 49 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80

bảng dữ liệu tải về

Link URL