R5F107ACMSP datasheet(33/107 Pages) RENESAS

33 / 107 page

RL78/G1C

ELECTRICAL SPECIFICATIONS (A: TA = -40 to +85

°C)

Page 33 of 135

R01DS0348EJ0100

Rev.1.00

Aug 08, 2013

Notes 1. Current flowing to VDD.

2. When high speed on-chip oscillator and high-speed system clock are stopped.

3. Current flowing only to the real-time clock (RTC) (excluding the operating current of the low-speed

on-chip ocsillator and the XT1 oscillator). The supply current of the RL78 microcontrollers is the sum of

the values of either IDD1 or IDD2, and IRTC, when the real-time clock operates in operation mode or HALT

mode.

When the low-speed on-chip oscillator is selected, IFIL should be added.

IDD2 subsystem clock

operation includes the operational current of the real-time clock.

4. Current flowing only to the 12-bit interval timer (excluding the operating current of the low-speed on-chip

ocsillator and the XT1 oscillator). The supply current of the RL78 microcontrollers is the sum of the

values of either IDD1 or IDD2, and IIT, when the 12-bit interval timer operates in operation mode or HALT

mode. When the low-speed on-chip oscillator is selected, IFIL should be added.

5. Current flowing only to the watchdog timer (including the operating current of the low-speed on-chip

oscillator). The supply current of the RL78 microcontrollers is the sum of IDD1, IDD2 or IDD3 and IWDT when

the watchdog timer is in operation.

6. Current flowing only to the A/D converter. The supply current of the RL78 microcontrollers is the sum of

IDD1 or IDD2 and IADC when the A/D converter operates in an operation mode or the HALT mode.

7. Current flowing only to the LVD circuit. The current value of the RL78/G1C is the sum of IDD1, IDD2 or IDD3

and ILVI when the LVD circuit operates in the Operating, HALT or STOP mode.

8. Current flowing only during data flash rewrite.

9. Current flowing only during self programming.

10. For shift time to the SNOOZE mode, see 19.3.3 SNOOZE mode in the RL78/G1C User’s Manual:

Hardware.

11. Current consumed only by the USB module and the internal power supply for the USB.

12. Includes the current supplied from the pull-up resistor of the UDP0 pin to the pull-down resistor of the

host device, in addition to the current consumed by this MCU during the suspended state.

Remarks 1. fIL:

Low-speed on-chip oscillator clock frequency

2. fSUB: Subsystem clock frequency (XT1 clock oscillation frequency)

3. fCLK: CPU/peripheral hardware clock frequency

4. Temperature condition of the TYP. value is TA = 25

°C

R5F107ACMSP bảng dữ liệu(PDF) 33 Page - Renesas Technology Corp