USB-SMBUS-CABLEZ, USB-5PSMBUS-CABLEZ

Rev. 0 | Page 2 of 4

EVALUATION BOARD SOFTWARE

DRIVER INSTALLATION

Version 4.0.0 or later of the ADM1062 to ADM1069 evaluation

software or Version 3.0.0 of the ADM1175/ADM1176/ADM1177/

ADM1178 and ADM119x evaluation software provides the

To install the driver software, perform the following steps:

1.

Install the evaluation software before the cable is plugged

in. If prompted by the software, restart the PC.

2.

Plug the cable into a free USB port on the PC. The operating

system recognizes that a new device has been attached and

asks if you want to install new drivers for it.

3.

Select the default option, which is to let the operating

system locate the drivers for you, and click Continue to

search for the drivers. Depending on your PC settings, you

may also be prompted that the driver you are installing is

unsigned. Click Continue Anyway if prompted to complete

the driver installation. The cable is now ready for use.

Note that on certain PC configurations you will be prompted to

install the drivers the first time you plug the cable into each of

the USB ports on the PC. Once this installation is complete for

a port, it does not need to be repeated.

For more information on these devices and to download the

evaluation software, visit www.analog.com.

WARNING

to ADM1069 evaluation board (EVAL-ADM106xEB), the

evaluation board power must be turned on before connecting

the dongle to the 3-pin header on the board. If this is not done,

damage to either the dongle and/or evaluation board may result.