STM8S003F3P6 datasheet(46/100 Pages) STMICROELECTRONICS

46 / 100 page

Electrical characteristics

Parameter conditions

9.1

Unless otherwise specified, all voltages are referred to VSS.

Minimum and maximum values

9.1.1

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100 % of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by

the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on characterization,

the minimum and maximum values refer to sample tests and represent the mean value plus

or minus three times the standard deviation (mean ± 3 Σ).

Typical values

9.1.2

Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 5 V. They are given

only as design guidelines and are not tested.

Typical ADC accuracy values are determined by characterization of a batch of samples from

a standard diffusion lot over the full temperature range, where 95% of the devices have an

error less than or equal to the value indicated (mean ± 2 Σ).

Typical curves

9.1.3

Unless otherwise specified, all typical curves are given only as design guidelines and are not

tested.

Loading capacitor

9.1.4

The loading conditions used for pin parameter measurement are shown in the following figure.

Figure 7: Pin loading conditions

50 pF

STM8 pin

Pin input voltage

9.1.5

The input voltage measurement on a pin of the device is described in the following figure.

DocID018576 Rev 3

46/100

STM8S003K3 STM8S003F3

Electrical characteristics

STM8S003F3P6 bảng dữ liệu(PDF) 46 Page - STMicroelectronics