PI3B3257LE datasheet(2/7 Pages) PERICOM

2 / 7 page

01/14/13

PI3B3257

3.3V, Quad 2:1 Mux/DeMux NanoSwitch™

Notes:

1. This parameter is determined by device characterization but is not production tested.

Storage Temperature .....................................................................–65°C to +150°C

Ambient Temperature with Power Applied ....................................–40°C to +85°C

Supply Voltage to Ground Potential.................................................–0.5V to +4.6V

DC Input Voltage .............................................................................–0.5V to +4.6V

DC Output Current........................................................................................ 120mA

Power Dissipation ............................................................................................ 0.5W

Note:

Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only

and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not

mplied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 3.3V ±10%)

Parameters

Description

Test Conditions(1)

Min. Typ.(2) Max. Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

IOZH

High Impedance Output Current

0 ≤ In, Yn ≤ VCC

±1

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18mA

–1.2

RON

Switch On-Resistance(3)

VCC = Min., VIN = 0.0V,

Ion = 48mA or 64mA

Ω

VCC = Min., VIN = 2.4V, ION = 15mA

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(1)

Description

Test Conditions

Typ.

Units

CIN

Input Capacitance

VIN = 0V

3.0

COFFYN

YN Capacitance, Switch OFF

17.0

COFFIN

IN Capacitance, Switch OFF

8.5

CON

IN/YN Capacitance, Switch ON

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between I and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the

voltages on the two (I,Y) pins.

13-0014

PI3B3257LE bảng dữ liệu(PDF) 2 Page - Pericom Semiconductor Corporation

PI3B3257LE bảng dữ liệu(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6 7

bảng dữ liệu tải về

Link URL