RT9715FPF datasheet(11/15 Pages) RICHTEK

11 / 15 page

RT9715

DS9715-03 April 2011

www.richtek.com

PCB Layout Guide

In order to meet the voltage drop, droop, and EMI

requirements, careful PCB layout is necessary. The

following guidelines must be followed :

Locate the ceramic bypass capacitors as close as

possible to the VIN pins of the RT9715.

Place a ground plane under all circuitry to lower both

resistance and inductance and improve DC and transient

performance (Use a separate ground and power plans if

possible).

Keep all VBUS traces as short as possible and use at

least 50-mil, 2 ounce copper for all VBUS traces.

Avoid vias as much as possible. If vias are necessary,

make them as large as feasible.

Place cuts in the ground plane between ports to help

reduce the coupling of transients between ports.

Locate the output capacitor and ferrite beads as close to

the USB connectors as possible to lower impedance

(mainly inductance) between the port and the capacitor

and improve transient load performance.

Locate the RT9715 as close as possible to the output

port to limit switching noise.

maximum power dissipation can be calculated by following

formula :

PD(MAX) = (TJ(MAX)

− TA) / θJA

Where TJ(MAX) is the maximum operation junction

temperature 100

°C, TAis the ambient temperature and the

θJA is the junction to ambient thermal resistance.

For recommended operating conditions specification of

RT9715, where TJ(MAX) is the maximum junction

temperature of the die (100

°C) and TA is the maximum

ambient temperature. The junction to ambient thermal

resistance

θJA is layout dependent. For SOT-23-5

packages, the thermal resistance

θJA is 250°C/W on the

standard JEDEC 51-3 single-layer thermal test board. And

for SOP-8 and MSOP-8 packages, the thermal resistance

θJA is 160°C/W. The maximum power dissipation at TA =

°C can be calculated by following formula :

PD(MAX) = (100

°C - 25°C) / (250°C/W) = 0.3W for

SOT-23-5 packages

PD(MAX) = (100

°C - 25°C) / (160°C/W) = 0.469W for

SOP-8/MSOP-8 packages

PD(MAX) = (100

°C - 25°C) / (108°C/W) = 0.694W for

WDFN-8L 3x3 packages

The maximum power dissipation depends on operating

ambient temperature for fixed TJ(MAX) and thermal resistance

θJA. For RT9715 packages, the Figure 2 of derating curves

allows the designer to see the effect of rising ambient

temperature on the maximum power allowed.

Figure 2. Derating Curves for RT9715 Package

0.1

0.2

0.3

0.4

0.5

0.6

0.7

0.8

1020

3040

5060

7080

90 100

Ambient Temperature (°C)

WDFN-8L 3x3

SOP-8/MSOP-8

SOT-23-5

Single Layer PCB

GND

GND_BUS

VIN

VOUT

VBUS

VIN

FLG

The input capacitor should

be placed as close as

possible to the IC.

Figure 3

RT9715FPF bảng dữ liệu(PDF) 11 Page - Richtek Technology Corporation

RT9715FPF bảng dữ liệu(HTML) 11 Page - Richtek Technology Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

bảng dữ liệu tải về

Link URL