| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
CDH2D09 bảng dữ liệu(PDF) 38 Page - Maxim Integrated Products |
|
|
|||||||||||||||||||||||||||||
CDH2D09 bảng dữ liệu(HTML) 38 Page - Maxim Integrated Products |
|
38 / 44 page ![]() PMIC with Integrated Charger and Smart Power Selector for Handheld Devices 38 ______________________________________________________________________________________ Active Discharge in Shutdown Each MAX8671X regulator (REG1–REG5) has an inter- nal 1k Ω resistor that discharges the output capacitor when the regulator is off. The discharge resistors ensure that the load circuitry powers down completely. The internal discharge resistors are connected when a regulator is disabled and when the device is in UVLO with an input voltage greater than 1.0V. With an input voltage less than 1.0V, the internal discharge resistors are not activated. Undervoltage and Overvoltage Lockout USB/DC UVLO Undervoltage lockout (UVLO) prevents an input supply from being used when its voltage is below the operat- ing range. When the USB voltage is less than the USB UVLO threshold (4.0V typ), the USB input is discon- nected from SYS, and UOK goes high impedance. When the DC voltage is less than the DC UVLO thresh- old (4.0V typ), the DC input is disconnected from SYS, and DOK goes high impedance. In addition, when both USB and DC are in UVLO, the battery charger is dis- abled, and BAT is connected to SYS through the inter- nal system load switch. REG1–REG4 are allowed to operate from the battery without power at USB or DC. REG5 is intended to power the system USB transceiver circuitry, which is only active when USB power is avail- able. Therefore, a valid source must be present on either the USB or DC input for REG5 to enable. UNPLUG EVENT VUSB 3.5V HIGH-Z UNPLUGGING USB WITH NOTHING TO DISCHARGE CUSB (VBAT = 3.3V). V5 SET FOR 3.3V IF VBAT ≥ 3.4V, VPV5 WILL REGULATE TO 3.3V IF VBAT ≤ 3.4V, VPV5 WILL BE SLIGHTLY LESS THAN VBAT (DROPOUT) VUOK V5 5V tDDREG5 = 120 μs (typ) RAPID DISCHARGE UNTIL VUSB DECAYS TO THE HIGHER OF 3.5V OR VBAT + 5OmV SLOW DISCHARGE AS THE MAX8671X DRAWS USB QUIESCENT CURRENT Figure 13. REG5 Disable Detail |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |