LifecyclePhase:

Revision

: 2

Expired Period: Forever

Release Date:2009-01-21 08:15:09.0

Technical Data Sheet

7383/R2C3-AMQB/X

Everlight Electronics Co., Ltd.

http\\:www.everlight.com

Rev 2

Page: 8 of 10

Device Number :

DLE-0000741

Prepared date:01-13-2009

Prepared : Flourix Chen

Prehead

laminar wave

Fluxing



Avoiding applying any stress to the lead frame while the LEDs are at high temperature

particularly when soldering.



Dip and hand soldering should not be done more than one time



After soldering the LEDs, the epoxy bulb should be protected from mechanical shock or

vibration until the LEDs return to room temperature.



A rapid-rate process is not recommended for cooling the LEDs down from the peak temperature.



Although the recommended soldering conditions are specified in the above table, dip or

handsoldering at the lowest possible temperature is desirable for the LEDs.



Wave soldering parameter must be set and maintain according to recommended temperature and

dwell time in the solder wave.

4. Cleaning



When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a

duration of no more than one minute. Dry at room temperature before use.