ICS9P935 datasheet(9/13 Pages) IDT

9 / 13 page

IDTTM/ICSTM

DDR I/DDR II Phase Lock Loop Zero Delay Buffer

ICS9P935

REV H

12/1/08

ICS9P935

DDR I/DDR II Phase Lock Loop Zero Delay Buffer

The IDT clock generator is a slave/receiver, I

2C component. It can read back the data stored in the latches for verification.

Read-Back will support SMBus block read protocol.

The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)

The input is operating at 3.3V logic levels.

The data byte format is 8 bit bytes.

To simplify the clock generator I

2C interface, the protocol is set to use only "Block-Writes" from the controller. The bytes must

be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte has been transferred.

The Command code and Byte count shown above must be sent, The data is loaded until a Stop sequence is issued.

At power-on, all registers are set to a default condition, as shown.

Notes:

General I

2C serial interface information for the ICS9P935

How to Write:

• Controller (host) sends a start bit.

• Controller (host) sends the write address D4

(H)

• ICS clock will

acknowledge

• Controller (host) sends the begining byte location = N

• ICS clock will

acknowledge

• Controller (host) sends the data byte count = X

• ICS clock will

acknowledge

• Controller (host) starts sending

Byte N through

Byte N + X -1

(see Note 2)

• ICS clock will

acknowledge each byte one at a time

• Controller (host) sends a Stop bit

How to Read:

• Controller (host) will send start bit.

• Controller (host) sends the write address D4

(H)

• ICS clock will

acknowledge

• Controller (host) sends the begining byte

location = N

• ICS clock will

acknowledge

• Controller (host) will send a separate start bit.

• Controller (host) sends the read address D5

(H)

• ICS clock will

acknowledge

• ICS clock will send the data byte count = X

• ICS clock sends

Byte N + X -1

• ICS clock sends

Byte 0 through byte X (if X

(H)

was written to byte 8).

• Controller (host) will need to acknowledge each byte

• Controllor (host) will send a not acknowledge bit

• Controller (host) will send a stop bit

ICS (Slave/Receiver)

ACK

Byte N + X - 1

Data Byte Count = X

Beginning Byte N

stoP bit

Index Block Write Operation

Slave Address D4(H)

Beginning Byte = N

WRite

starT bit

Controller (Host)

TstarT bit

WRite

Repeat starT

ReaD

Beginning Byte N

Byte N + X - 1

Not acknowledge

PstoP bit

ICS (Slave/Receiver)

Controller (Host)

ACK

Data Byte Count = X

ACK

Slave Address D5(H)

Index Block Read Operation

Slave Address D4(H)

Beginning Byte = N

ACK

ICS9P935 bảng dữ liệu(PDF) 9 Page - Integrated Device Technology

ICS9P935 bảng dữ liệu(HTML) 9 Page - Integrated Device Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

bảng dữ liệu tải về

Link URL