082-8113-404 datasheet(8/24 Pages) MAGNETROL

8 / 24 page

50-613 Kotron Series 82 CE RF Level Transmitter

10. Tighten both socket head screws on the clamp to approxi-

mately 35 in./lbs of torque. Slip the Mylar insulator over

the clamp.

11. Screw the transmitter onto the probe until hand tight.

The housing can be wrench-tightened to align the conduit

connection with the conduit. Refer to Figure 2 on page 3.

1.5.2.1 Integral Electronics

1. Remove the housing cover. Locate the white wire which is

fastened to the (+) probe terminal. Connect the free end

of this wire to the probe connection screw.

2. Proceed to Wiring, Section 1.6.

1.5.2.2 Remote Electronics

1. Remove the probe housing cover. Connect the positive

lead of the interconnection cable (supplied by Magnetrol),

to the screw terminal at the top of the probe. Connect the

negative lead to the green ground screw at the base of the

housing. Cut the shield; do not connect it at probe end.

Refer to Figure 4 on page 4.

2. Install the transmitter housing using the bracket (supplied

by Magnetrol). Make sure to provide adequate clearance

to remove the housing cover. Refer to Figure 4 on page 4.

3. Remove the transmitter housing cover. Connect the

positive lead of the interconnection cable to the (+) probe

terminal. Connect the negative lead and shield to the

(–) probe terminal. Refer to Figure 3 on page 3.

4. Proceed to Wiring, Section 1.6.

082-8113-404 bảng dữ liệu(PDF) 8 Page - Magnetrol International, Inc.