SWS-L datasheet(11/19 Pages) TDK

11 / 19 page

・All specifications are subject to change without notice.

SWS 600L, 1000L

Please pay extra attention to the wiring. Incorrect connec-

tion will damage the power supply.

● When connecting input, output wiring and CN1, CN2,

CN3, input AC-Line should be oﬀ.

● Input wiring and output wiring shall be separated to im-

prove noise sensibility.

● The protective earth (PE) must be connected to the

ter-

minal or chassis.

● Remote sensing lines shall be twisted or used shielded wires.

● Remote ON/OFF control lines shall be twisted or used

shielded wires. Separate from load line.

● Output current of each terminal screw shall be 60A or

less for SWS600L.

Panel Side

● Basic connection (Local sensing)

Connect “+S” terminal to “+Vm” terminal and “-S” terminal to

“-Vm” terminal.

SWS600L

SWS1000L

● Remote sensing required

Connect “+S” terminal to “+” terminal of load and “-S” termi-

nal to “-” output terminal of load with wires.

SWS600L

SWS1000L

● ALM signal output required

Open collector method shown below shall be used.

“G1” terminal is ground for “ALM” terminal.

SWS600L

SWS1000L

CN1(or CN2)

twist or shield

CN1(or CN2)

twist or shield

CN1(or CN2)

CN3

signal

ground

ALM

signal

output

CN1(or CN2)

CN3

signal

ground

ALM

signal

output

CN1(or CN2)

3. Terminal Connection Method

SWS-L bảng dữ liệu(PDF) 11 Page - TDK Electronics

SWS-L bảng dữ liệu(HTML) 11 Page - TDK Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

bảng dữ liệu tải về

Link URL