910GL datasheet(93/426 Pages) INTEL

93 / 426 page

Host Bridge/DRAM Controller Registers (D0:F0)

Datasheet

4.1.30

ERRCMD—Error Command (D0:F0)

PCI Device:

Address Offset:

CAh

Default Value:

0000h

Access:

R/W

Size:

16 bits

This register controls the (G)MCH responses to various system errors. Since the (G)MCH does

not have an SERR# signal, SERR messages are passed from the (G)MCH to the Intel ICH6 over

DMI. When a bit in this register is set, a SERR message will be generated on DMI when the

corresponding flag is set in the ERRSTS register. The actual generation of the SERR message is

globally enabled for Device 0 via the PCI Command register.

Bit

Access &

Default

Description

15:12

Reserved

R/W

SERR on (G)MCH Thermal Sensor Event (TSESERR)

1 = The (G)MCH generates a DMI SERR special cycle when bit 11 of the

ERRSTS is set. The SERR must not be enabled at the same time as the SMI

for the same thermal sensor event.

0 = Reporting of this condition via SERR messaging is disabled.

Reserved

R/W

SERR on LOCK to non-DRAM Memory (LCKERR)

1 = The (G)MCH will generate a DMI SERR special cycle whenever a processor

lock cycle is detected that does not hit DRAM.

0 = Reporting of this condition via SERR messaging is disabled.

R/W

SERR on DRAM Refresh Timeout (DRTOERR)

1 = The (G)MCH generates a DMI SERR special cycle when a DRAM Refresh

timeout occurs.

0 = Reporting of this condition via SERR messaging is disabled.

7:0

Reserved

910GL bảng dữ liệu(PDF) 93 Page - Intel Corporation

910GL bảng dữ liệu(HTML) 93 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL