M95010 datasheet(10/43 Pages) STMICROELECTRONICS

tên linh kiện	M95010

Giải thích chi tiết về linh kiện	4 Kbit, 2 Kbit and 1 Kbit serial SPI bus EEPROM with high-speed clock

PDF	43 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

10 / 43 page

Signal description

M95040, M95020, M95010

10/43

Doc ID 6512 Rev 8

2.9.3

Power-up conditions

When the power supply is turned on, VCC rises continuously from VSS to VCC. During this

time, the Chip Select (S) line is not allowed to float but should follow the VCC voltage. It is

therefore recommended to connect the S line to VCC via a suitable pull-up resistor (see

Figure 3).

In addition, the Chip Select (S) input offers a built-in safety feature, as the S input is edge

sensitive as well as level sensitive: after power-up, the device does not become selected

until a falling edge has first been detected on Chip Select (S). This ensures that Chip Select

(S) must have been high, prior to going low to start the first operation.

The VCC voltage has to rise continuously from 0 V up to the minimum VCC operating voltage

defined in Table 8, Table 9 and Table 10 and the rise time must not vary faster than 1 V/µs.

2.9.4

Power-down

During power-down (continuous decrease in the VCC supply voltage below the minimum

VCC operating voltage defined in Table 8, Table 9 and Table 10), the device must be:

●

deselected (Chip Select S should be allowed to follow the voltage applied on VCC)

●

in Standby Power mode (there should not be any internal write cycle in progress).

M95010 bảng dữ liệu(PDF) 10 Page - STMicroelectronics