LIS331DLHTR datasheet(16/38 Pages) STMICROELECTRONICS

tên linh kiện	LIS331DLHTR

Giải thích chi tiết về linh kiện	MEMS digital output motion sensor ultra low-power high performance 3-axes ?쐍ano??accelerometer

PDF	38 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

16 / 38 page

Application hints

LIS331DLH

16/38

Doc ID 15094 Rev 3

Application hints

Figure 5.

LIS331DLH electrical connection

The device core is supplied through Vdd line while the I/O pads are supplied through

Vdd_IO line. Power supply decoupling capacitors (100 nF ceramic, 10 µF Aluminum) should

be placed as near as possible to the pin 14 of the device (common design practice).

All the voltage and ground supplies must be present at the same time to have proper

behavior of the IC (refer to

Figure 5). It is possible to remove Vdd maintaining Vdd_IO

without blocking the communication bus, in this condition the measurement chain is

powered off.

The functionality of the device and the measured acceleration data is selectable and

accessible through the I2C or SPI interfaces.When using the I2C, CS must be tied high.

The functions, the threshold and the timing of the two interrupt pins (INT 1 and INT 2) can be

completely programmed by the user through the I2C/SPI interface.

4.1

Soldering information

The LGA package is compliant with the ECOPACK®, RoHS and “Green” standard.

It is qualified for soldering heat resistance according to JEDEC J-STD-020C.

Leave “pin 1 indicator” unconnected during soldering.

Land pattern and soldering recommendations are available at www.st.com.

10µF

Vdd

100nF

GND

Vdd_IO

INT 1

Digital signal from/to signal controller.Signal’s levels are defined by proper selection of Vdd_IO

TOP VIEW

INT 2

LIS331DLHTR bảng dữ liệu(PDF) 16 Page - STMicroelectronics