SSL2103T datasheet(9/21 Pages) NXP

9 / 21 page

SSL2103

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 2 — 25 November 2010

9 of 21

NXP Semiconductors

SSL2103

SMPS controller IC for dimmable LED lighting

8.6 Demagnetization

The system operates in discontinuous conduction mode if the AUX pin is connected. As

long as the secondary stroke has not ended, the oscillator will not start a new primary

stroke. During the first tsup(xfmr_ring) seconds, demagnetization recognition is suppressed.

This suppression may be necessary in applications where the transformer has a large

leakage inductance and at low output voltages.

8.7 Overcurrent protection

The cycle-by-cycle peak drain current limit circuit uses the external source resistor RSENSE

to measure the current. The circuit is activated after the leading edge blanking time tleb.

The protection circuit limits the source voltage over the RSENSE1 resistor to Vth(ocp)SOURCE,

and thus limits the primary peak current.

8.8 Short-winding protection

The short-winding protection circuit is also activated after the leading edge blanking time.

If the source voltage exceeds the short-winding protection threshold voltage

Vth(swp)SOURCE, the IC stops switching. Only a power-on reset will restart normal operation.

The short-winding protection also protects in case of a secondary diode short circuit.

8.9 Overtemperature protection

Accurate temperature protection is provided in the device. When the junction temperature

exceeds the thermal shut-down temperature, the IC stops switching. During thermal

protection, the IC current is lowered to the start-up current. The IC continues normal

operation as soon as the overtemperature situation has disappeared.

RSENSE is the resistor between the SOURCE pin and GND

SSL2103T bảng dữ liệu(PDF) 9 Page - NXP Semiconductors