SST25WF080 datasheet(4/29 Pages) SST

4 / 29 page

Advance Information

8Mbit 1.8V SPI Serial Flash

SST25WF080

S71203-03-000

04/10

MEMORY ORGANIZATION

The SST25WF080 SuperFlash memory arrays are orga-

nized in uniform 4 KByte sectors with 16 KByte, 32 KByte,

and 64 KByte overlay erasable blocks.

DEVICE OPERATION

The SST25WF080 are accessed through the SPI (Serial

Peripheral Interface) bus compatible protocol. The SPI bus

consist of four control lines; Chip Enable (CE#) is used to

select the device, and data is accessed through the Serial

Data Input (SI), Serial Data Output (SO), and Serial Clock

(SCK).

The SST25WF080 support both Mode 0 (0,0) and Mode 3

(1,1) of SPI bus operations. The difference between the

two modes, as shown in Figure 4, is the state of the SCK

signal when the bus master is in Stand-by mode and no

data is being transferred. The SCK signal is low for Mode 0

and SCK signal is high for Mode 3. For both modes, the

Serial Data In (SI) is sampled at the rising edge of the SCK

clock signal and the Serial Data Output (SO) is driven after

the falling edge of the SCK clock signal.

FIGURE 4: SPI Protocol

1203 F03.0

MODE 3

SCK

CE#

MODE 3

DON'T CARE

Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0

MODE 0

HIGH IMPEDANCE

MSB

SST25WF080 bảng dữ liệu(PDF) 4 Page - Silicon Storage Technology, Inc