SA8803 datasheet(5/10 Pages) SAMES

5 / 10 page

SA8803

sames

5/10

Constant Current Mode

When the CC pin is pulled high, the device will draw a constant current from the V

supply which is equal to all LED's in the "on"condition regardless of the status of the

LED's.

Clock Characteristics

CLK is the internal synchronous clock derived from the asynchronous external clock

applied at the CLK input pin. It divides the external clock by 8. Theoretically the

rising edge of S

CLK (synchronous Clock) should be in the middle of every bit, as

shown in Figure 4. Because of phase shift due to the clock frequency being more

or less than 8 times the baud rate, this edge may shift its position with regard to the

bit period (B

P). The extreme case that may still be tolerated is an edge arriving at

either the beginning, or end of bit 11. This represents the maximum shift that can

be tolerated for valid data to be received for an inaccurate input clock frequency

O).

LED Intensity Control

The LED "on" current (I

D), is determined by the current flowing from the INTENS pin

through the external resistor. The values of I

D can be calculated as follows:

D = KT.

- Current Transfer Ratio of the Internal Current Mirror (typically 10.0)

- The programming resistor value

X - The voltage drop across the external resistor (internally controlled to 5.0V)

SA8803 bảng dữ liệu(PDF) 5 Page - Sames