| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
EP1M350 bảng dữ liệu(PDF) 14 Page - Altera Corporation |
|
|
|||||||||||||||||||||||||||||
EP1M350 bảng dữ liệu(HTML) 14 Page - Altera Corporation |
|
14 / 34 page ![]() 1–14 Chapter 1: Enhanced Configuration Devices (EPC4, EPC8, and EPC16) Data Sheet Functional Description Configuration Handbook (Complete Two-Volume Set) © December 2009 Altera Corporation 1 The external flash interface signals cannot be shared between multiple enhanced configuration devices because this causes contention during in-system programming and configuration. During these operations, the controller chips inside the enhanced configuration devices are actively accessing flash memory. Therefore, enhanced configuration devices do not support shared flash bus interfaces. The enhanced configuration device controller chip accesses flash memory during: ■ FPGA configuration—reading configuration data from flash ■ JTAG-based flash programming—storing configuration data in flash ■ At POR—reading option bits from flash During these operations, the external FPGA or processor must tri-state its interface to the flash memory. After configuration and programming, the enhanced configuration device’s controller tri-states the internal interface and goes into an idle mode. To interrupt a configuration cycle in order to access the flash via the external flash interface, the external device can hold the FPGA’s nCONFIG input low. This keeps the configuration device in reset by holding the nSTATUS-OE line low, allowing external flash access. f For more information about the software support for the external flash interface feature, refer to the Altera Enhanced Configuration Devices chapter in volume 2 of the Configuration Handbook. For details about flash commands, timing, memory organization, and write protection features, refer to the following documents: ■ For Micron flash-based EPC4, refer to the Micron Flash Memory MT28F400B3 Data Sheet at www.micron.com. ■ For Sharp flash-based EPC16, refer to the Sharp LHF16J06 Data Sheet Flash Memory Used in EPC16 Devices at www.sharpsma.com. ■ For the Intel Advanced Boot Block Flash Memory (B3) 28F008/800B3, 28F016/160B3, 28F320B3, 28F640B3 Datasheet, visit www.intel.com. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |