SPBT2532C2AT datasheet(33/48 Pages) STMICROELECTRONICS

33 / 48 page

SPBT2532C2.AT

Commands

Doc ID 16089 Rev 3

33/48

Where

[Enable/Disable] is an e or E character to enable this parameter and a d or D

character to disable it.

C.20.2

Responses

If the feature is successfully enabled, the response is:

AT-AB HostEvent Enabled

If the feature is successfully disabled there is no response because the events have been

disabled.

C.21

LocalName

The LocalName command is used to set the name of the device to the name that is reported

during device discoveries. By default, the abSerial interface uses Amp’edBTDevice.

Changing the name using this command does not permanently change the local name.

C.21.1

Syntax

AT+AB LocalName [name]

Where

[name] is a string for the new local name (up to 50 characters). The space character

is allowed; the name is assumed to be all text up to the end of the command.

C.21.2

Responses

If the operation is successful, the response is:

AT-AB LocalNameOk

C.22

Park

The Park command is used to switch a device from active mode to park mode.

C.22.1

Syntax

AT+AB Park [BD address] [Beacon Period]

Where

[BD address] is the BD address of the device to be switched to active mode.

[Beacon Period] is given in slots from 200-10,000.

C.22.2

Responses

If the operation is successful, the response is:

AT-AB ParkMode

C.23

RemoteCommand

The RemoteCommand command is used to enable/disable the remote command mode.

This setting is stored in persistent memory, and will be retained after each reset.

Additionally, the new setting will take effect upon the next device reset.

SPBT2532C2AT bảng dữ liệu(PDF) 33 Page - STMicroelectronics

SPBT2532C2AT bảng dữ liệu(HTML) 33 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

bảng dữ liệu tải về

Link URL