PIC18F44J50 datasheet(7/12 Pages) MICROCHIP

7 / 12 page

 2010 Microchip Technology Inc.

DS80436C-page 7

PIC18F46J50 FAMILY

7. Module: DC Characteristics (Supply

Voltage)

The minimum operating voltage (VDD) parameter

(D001) for “F” devices is 2.25V. For “LF” devices

(such as the PIC18LF46J50), the minimum rated

VDD operating voltage is 2.0V.

Work around

None.

Affected Silicon Revisions

8. Module: Analog-to-Digital Converter

(Band Gap Reference)

At high VDD voltages (ex: >2.5V), performing an

ADC conversion on Channel 15 (the VBG absolute

reference) can temporarily disturb the reference

voltage supplied to the HLVD module and compar-

ator module (only when configured to use the

VIRV). At lower VDD voltages, the disturbance will

be less or non-existent.

Work around

If precise HLVD or comparator VIRV thresholds are

required at high VDD voltages, avoid performing

ADC conversions on Channel 15 while simultane-

ously using the HLVD or comparator VIRV. If an

ADC conversion is performed on Channel 15, a

settling time of approximately 100

s is needed

before the reference voltage fully returns to the

original value.

Affected Silicon Revisions

9. Module: Charge Time Measurement Unit

(CTMU)

On an “F” device, the CTMU current source will stop

sourcing current if the applied VDD voltage falls

below the LVDSTAT (WDTCON<6>) threshold

(2.45V nominal). When VDD is above the LVDSTAT

threshold, the CTMU will function normally. This

issue does not apply to “LF” devices. The current

source will continue to function normally at all rated

voltages for these devices.

Work around

None

Affected Silicon Revisions

PIC18F44J50 bảng dữ liệu(PDF) 7 Page - Microchip Technology

PIC18F44J50 bảng dữ liệu(HTML) 7 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

bảng dữ liệu tải về

Link URL