(6) ESD ( eletrostatic discharge ) protection ( base on machine mode )

＊

The product is Gallium Nitride ( GaN ) based light emitting diode ( LED ) and is extremely

sensitive to ESD. Users are strongly recommended to take necessary meter to test the

static electricty and avoid ESD when handling this product.

＊

Proper grounding of machines ( via 1MΩ ), using static disspative mats, containers, working

uniforms and shoes are considered to be effective against ESD.

＊

An ionizer is recommended in the facility or environment where ESD may be generated

easily, and soldering iron with a grounded tip is also recommended.

＊

When inspecting the final products in which LEDs are assembled, it is recommended

to check whether the assembled LEDs are damaged by ESD or not. It is simple to find

damaged LEDs by light-on or VF test at lower current ( below 1mA is recommended ).

＊

ESD damaged LEDs will show some unusual characteristics such as the remarkable

increasing of leak current, the decreasing of forward voltage, or the LEDs do not light on

at the low current.

(7) Other

＊

Care must be taken to ensure that the reverse voltage will not exceed the absolute maximum

rating when using the LEDs with matrix drive.

＊

The LED light output is strong enough to injure human eyes. Precaution must be taken to

prevent looking directly at the LEDs with unaided eyes for more than a few seconds.

＊

The LEDs described here are intended to be used for ordinary electronic equipment, please

consult Bright View's sales department in advance for information on applications.

＊

Installing a protection device in the LED driving circuit to avoid surge current exceeding the

max rating during on/off switching.

＊

The appearance and specifications of the product may be modified for improvement

without notice.

＊

Please use the product within 168 hours after opening the seal and keep under 30 ℃

and 70% humidity.

＊

Bright View will not be responsible for any claim for damage if the user use the product

without following the caution or instruction of the specification.

BSV08WALN

Bright View Electronics

Date:2008/02/18

Page: 12 of 12

Version A