AS8500 - Data Sheet

austriamicrosystems

Revision 1.2, 08-Junel-06

www.austriamicrosystems.com

Page 27 of

41

The trailing edge of INTN signals the start of a new measurement.

The determination of Tcnv and Tres from the parameter settings is:

Tcnv

% R1/(fovs*2)

Tres = MM*Tcnv*R2*2

with R1=OSR and R2=number of averages

8.3

SDI bus operation

SDI bus is a 2-line bi-directional interface between one master and one slave unit. Typically the master unit is a microcontroller with software-

implemented SDI protocol. The ASSP is always the slave unit. SDI bus operation is presented on figure 6.

During data transfers the sdat signal changes while sclk is low. The sdat signal can change while sclk is high only to generate start or

exception conditions.

Strobe ASSP

The master unit always generates the sclk signal.

The master unit generates the sdat signal in start, direction, address, master-write data and exception conditions. The master sdat pin is in

high-impedance state in master-read data condition.

INTN

Tres

Tcnv

start measurement i

i-1

i+1

i-2

i-1

i

available

results on SDI

SDAT

sclk

Start

Direction

Data transfer

Address

Register data

Exception

Figure 6: SDI bus operation