ST7565V datasheet(45/72 Pages) SITRONIX

45 / 72 page

ST7565V

Ver 1.5b

45/72

2009/09/14

LCD Bias Set

This command selects the voltage bias ratio required for the liquid crystal display.

Select Status

R/W

/RD

/WR

D0 1/65duty

1/49duty

1/33duty

1/55duty

1/53duty

1/9 bias

1/8 bias

1/6 bias

1/8 bias

1/7 bias

1/6 bias

1/5 bias

1/6 bias

Read/Modify/Write

This command is used paired with the “END” command. Once this command has been input, the display data read command

does not change the column address, but only the display data write command increments (+1) the column address. This

mode is maintained until the END command is input. When the END command is input, the column address returns to the

address it was at when the read/modify/write command was entered. This function makes it possible to reduce the load on the

MPU when there are repeating data changes in a specified display region, such as when there is a blanking cursor.

R/W

/RD

/WR

D7 D6 D5 D4 D3 D2 D1 D0

* Even in read/modify/write mode, other commands aside from display data read/write commands can also be used.

Yes

Read-Modify-Write

Done

Page Address Set

Column Address Set

Finished?

Dummy Read

Read-Modify-Write Cycle

Data Read

Modify Data

Data Write (at same Address)

Figure 24 Command Sequence For read modify write

ST7565V bảng dữ liệu(PDF) 45 Page - Sitronix Technology Co., Ltd.

ST7565V bảng dữ liệu(HTML) 45 Page - Sitronix Technology Co., Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

bảng dữ liệu tải về

Link URL