ATmega16HVB datasheet(155/273 Pages) ATMEL

155 / 273 page

155

8042A–AVR–07/09

ATmega16HVB/32HVB

26.2

26.2.1

CBCR – Cell Balancing Control Register

• Bit 7:4 – Res: Reserved Bits

These bits are reserved bits in the ATmega16HVB/32HVB and will always read as zero.

• Bit 3 – CBE4: Cell Balancing Enable 4

When this bit is set, the integrated Cell Balancing FET between terminals PV4 and PV3 will be

enabled. When the bit is cleared, the Cell Balancing FET will be disabled. The Cell Balancing

FETs are always disabled in Power-off mode. CBE4 cannot be set if CBE3 is set.

• Bit 2 – CBE3: Cell Balancing Enable 3

When this bit is set, the integrated Cell Balancing FET between terminals PV3 and PV2 will be

enabled. When the bit is cleared, the Cell Balancing FET will be disabled. The Cell Balancing

FETs are always disabled in Power-off mode. CBE3 cannot be set if CBE2 or CBE4 is set.

• Bit 1 – CBE2: Cell Balancing Enable 2

When this bit is set, the integrated Cell Balancing FET between terminals PV2 and PV1 will be

enabled. When the bit is cleared, the Cell Balancing FET will be disabled. The Cell Balancing

FETs are always disabled in Power-off mode. CBE2 cannot be set if CBE1 or CBE3 is set.

• Bit 0 – CBE1: Cell Balancing Enable 1

When this bit is set (one), the integrated Cell Balancing FET between terminals PV1 and NV will

be enabled. When the bit is cleared (zero), the Cell Balancing FET will be disabled. The Cell Bal-

ancing FETs are always disabled in Power-off mode. CBE1 cannot be set if CBE2 is set.

Bit

654

(0xF1)

–

CBE4

CBE3

CBE2

CBE1

CBCR

Read/Write

R/W

Initial Value

ATmega16HVB bảng dữ liệu(PDF) 155 Page - ATMEL Corporation