ATmega169P datasheet(136/393 Pages) ATMEL

tên linh kiện	ATmega169P

Giải thích chi tiết về linh kiện	8-bit Microcontroller with 16K Bytes In-System Programmable Flash

PDF	393 Pages

Scroll/Zoom	100%

nhà sản xuất	ATMEL [ATMEL Corporation]

Trang chủ	http://www.atmel.com

Logo

136 / 393 page

136

8018N–AVR–08/09

ATmega169P

Enabling and disabling of the clock input must be done when T1/T0 has been stable for at least

one system clock cycle, otherwise it is a risk that a false Timer/Counter clock pulse is generated.

Each half period of the external clock applied must be longer than one system clock cycle to

ensure correct sampling. The external clock must be guaranteed to have less than half the sys-

tem clock frequency (f

ExtClk < fclk_I/O/2) given a 50/50% duty cycle. Since the edge detector uses

sampling, the maximum frequency of an external clock it can detect is half the sampling fre-

quency (Nyquist sampling theorem). However, due to variation of the system clock frequency

and duty cycle caused by Oscillator source (crystal, resonator, and capacitors) tolerances, it is

recommended that maximum frequency of an external clock source is less than f

clk_I/O/2.5.

An external clock source can not be prescaled.

Figure 16-2. Prescaler for Timer/Counter0 and Timer/Counter1

(1)

Note:

1. The synchronization logic on the input pins (

T1/T0) is shown in Figure 16-1.

PSR10

Clear

clk

I/O

Synchronization

ATmega169P bảng dữ liệu(PDF) 136 Page - ATMEL Corporation