V7.1 1/08

9

Datalogger Settings

Press LOGGER to access the menu page

Sample Rate Setup

Number of Data Points

Select the desired number of data samples to log: 1000 / 2000 / 4000/ 8000 / 12000 /

16000. Scroll up or down to located the value and then click OK to save.

For example, to select 1,000 samples, the logger will stop logging (and will power off) when

1000 data points have been collected. Datalogging ceases when the datalogger is full. The

yellow LED will stop flashing when datalogging ceases.

Sample Rate

Select the sampling rate in seconds (1 second to 12 hours). Scroll up to increase the time

or down to decrease the time in seconds. The defaults sample rate is 2 seconds.

Start Modes

Scheduled Start

Scheduled Start sets the desired datalogging Start Date and Start Time. The datalogger

will start when the clock reaches the user programmed time and date. Ensure that the

datalogger is set to the current date and time.

Magnetic Start

Connect the datalogger to the PC to begin configuring the Magnetic start mode. Select

Magnetic and ensure that the datalogger is set to the current date and time. Enter the

desired ID (if any) and then press "OK" to confirm the Magnetic start setting. To start

datalogging in Magnetic mode, pass a strongly magnetized object by the bottom of the

datalogger. The LED will start flashing. Flashing rate depends on the sampling rate

programmed.

Immediate Start

The datalogger starts recording when the “OK” button is pressed.