SH72531FCC datasheet(9/56 Pages) RENESAS

9 / 56 page

Section 1 Connecting the Emulator with the User System

Rev. 2.00 Jun. 08, 2009 Page 3 of 46

REJ10J1941-0200

1.2

Connecting the Emulator with the User System

To connect the E10A-USB emulator (hereinafter referred to as the emulator), the H-UDI port

connector must be installed on the user system to connect the user system interface cable. When

designing the user system, refer to the recommended circuit between the H-UDI port connector

and the MCU. In addition, read the E10A-USB emulator user's manual and hardware manual for

the related device.

Table 1.2 shows the type number of the emulator, the corresponding connector type, and the use of

AUD function.

Table 1.2 Type Number, AUD Function, and Connector Type

Type Number

Connector

AUD Function

HS0005KCU02H

36-pin connector

Available

HS0005KCU01H, HS0005KCU02H

14-pin connector

Not available

HS0005KCU02H

38-pin connector

Available

The H-UDI port connector has the 36-pin, 14-pin, and 38-pin types as described below. Use them

according to the purpose of the usage.

1. 36-pin type (with AUD function; compatible with the E200F emulator)

The AUD trace function is supported. A large amount of trace information can be acquired in

realtime. The window trace function is also supported for acquiring memory access in the

specified range (memory access address or memory access data) by tracing.

2. 14-pin type (without AUD function)

The AUD trace function cannot be used because only the H-UDI function is supported. Since

the 14-pin type connector is smaller than the 36-pin type (1/2.5), the size of the area where the

connector is installed on the user system can be reduced.

3. 38-pin type (with AUD function)

The AUD trace function is supported. As well as the 36-pin type, a large amount of trace

information can be acquired in realtime. Since the 38-pin type connector is smaller than the

36-pin type (1/2.5), the size of the area where the connector is installed on the user system can

be reduced. To use the 38-pin type connector, however, an optional cable (HS0005ECK01H)

is required.

SH72531FCC bảng dữ liệu(PDF) 9 Page - Renesas Technology Corp