LTM8032MPVPBF datasheet(6/20 Pages) LINER

6 / 20 page

LTM8032

8032fa

–10

VIN = 13V

VOUT = 10V AT 2A

100 200 300 400 500

FREQUENCY (MHz)

600 700 800 900 1000

8031 G21

–10

VIN = 36V

VOUT = 10V AT 2A

100 200 300 400 500

FREQUENCY (MHz)

600 700 800 900 1000

8031 G20

TYPICAL PERFORMANCE CHARACTERISTICS

Temperature Rise vs

Load Current, VOUT = 10V

Radiated Emissions

TA = 25°C, unless otherwise noted.

LOAD CURRENT (mA)

2000

8032 G19

500

1000

1500

2500

24VIN

36VIN

PIN FUNCTIONS

VIN (Bank 3): The VIN pin supplies current to the LTM8032’s

internal regulator and to the internal power switch. This

pin must be locally bypassed with an external, low ESR

capacitor of at least 2.2μF.

FIN (K3, L3): Filtered Input. This is the node after the input

EMI ﬁlter. Use this only if there is a need to modify the

behavior of the integrated EMI ﬁlter or if VIN rises or falls

rapidly; otherwise, leave these pins unconnected. See the

Applications Information section for more details.

GND (Bank 2): Tie these GND pins to a local ground plane

below the LTM8032 and the circuit components. Return

the feedback divider (RADJ) to this net.

VOUT (Bank 1): Power Output Pins. Apply the output ﬁlter

capacitor and the output load between these pins and

GND pins.

AUX (Pin H5): Low Current Voltage Source for BIAS. In

many designs, the BIAS pin is simply connected to VOUT.

The AUX pin is internally connected to VOUT and is placed

adjacent to the BIAS pin to ease printed circuit board rout-

ing. Although this pin is internally connected to VOUT, do

not connect this pin to the load. If this pin is not tied to

BIAS, leave it ﬂoating.

BIAS (Pin H4): The BIAS pin connects to the internal power

bus. Connect to a power source greater than 2.8V. If the

output is greater than 2.8V, connect this pin to AUX. If the

output voltage is less, connect this to a voltage source

between 2.8V and 25V. Also, make sure that BIAS + VIN

is less than 56V.

RUN/SS (Pin L5): Pull RUN/SS pin to less than 0.2V to

shut down the LTM8032. Tie to 2.5V or more for normal

operation. If the shutdown feature is not used, tie this pin

to the VIN pin. RUN/SS also provides a soft-start function;

see the Applications Information section.

RT (Pin G7): The RT pin is used to program the switching

frequency of the LTM8032 by connecting a resistor from

this pin to ground. The Applications Information section of

the data sheet includes a table to determine the resistance

value based on the desired switching frequency. Minimize

capacitance at this pin.

SHARE (Pin H7): Tie this to the SHARE pin of another

LTM8032 when paralleling the outputs. Otherwise, do

not connect.

LTM8032MPVPBF bảng dữ liệu(PDF) 6 Page - Linear Technology

LTM8032MPVPBF bảng dữ liệu(HTML) 6 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

bảng dữ liệu tải về

Link URL