LT3582 datasheet(5/28 Pages) LINER

5 / 28 page

LT3582/LT3582-5/LT3582-12

3582512f

SYMBOL

PARAMETER

CONDITIONS

MIN

TYP

MAX

UNITS

tHD,DATRCV

Data Hold Time Receiving

LT3582 Receiving Data from Host

0ns

tSU,DAT

Data Setup Time

250

SDA Fall Time

400pF load, VIN ≥ 2.5V

250

ELECTRICAL CHARACTERISTICS The l denotes the speciﬁcations which apply over the full operating

temperature range, otherwise speciﬁcations are at TA = 25°C. VIN = 3.6V, VSHDN = VIN unless otherwise noted. (Note 3)

Note 1: Stresses beyond those listed under Absolute Maximum Ratings

may cause permanent damage to the device. Exposure to any Absolute

Maximum Rating condition for extended periods may affect device

reliability and lifetime.

Note 2: LT3582 only.

Note 3: The LT3582E is guaranteed to meet performance speciﬁcations

from 0°C to 125°C junction temperature. Speciﬁcations over the –40°C

to 125°C operating junction temperature range are assured by design,

characterization and correlations with statistical process controls.

Note 4: These speciﬁcations apply to the VP trim bits in REG0 using

a 50mV LSB and do not include the additional VPLUS trim bit. See

Registers and OTP in the Applications Information section.

Note 5: This IC includes over-temperature protection that is intended

to protect the device during momentary overload conditions. Junction

temperature will exceed the maximum operating junction temperature

when over-temperature protection is active. Continuous operation above

the speciﬁed maximum operating junction temperature may impair

device reliability.

Note 6: Output voltage is measured under non-switching test conditions

approximating a moderate load current from the output.

I2C Timing Characteristics

LT3582 bảng dữ liệu(PDF) 5 Page - Linear Technology

LT3582 bảng dữ liệu(HTML) 5 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

bảng dữ liệu tải về

Link URL