SLD332F

- 4 -

Notes On Handling

Care should be taken for the following points when using this product.

1. This product corresponds to a Class 4 product under IEC60825-1 and JIS standard C6802 “Laser Product

Emission Safety Standards”.

2. Eye protection against laser beams

Take care not to allow laser beams to enter your eyes under any circumstances.

For observing laser beams, ALWAYS use safety goggles that block laser beams. Usage of IR scopes,

IR cameras and fluorescent plates is also recommended for monitoring laser beams safely.

3. Gallium Arsenide

This product uses gallium arsenide (GaAs). This is not a problem for normal use, but GaAs vapors may be

potentially hazardous to the human body. Therefore, never crush, heat to the maximum storage

temperature or higher, or place the product in your mouth.

In addition, the following disposal methods are recommended when disposing of this product.

(1)

Engaging the services of a contractor certified in the collection, transport and intermediate treatment

of items containing arsenic.

(2)

Managing the product through to final disposal as specially managed industrial waste which is

handled separately from general industrial waste and household waste.

4. Prevention of surge current and electrostatic discharge

Laser diodes are most sensitive to electrostatic discharge among semiconductors. When a large current is

passed through the laser diode for even an extremely short time, the strong light emitted from the laser

diode promotes deterioration and then destruction of the laser diode. Therefore, note that surge current

should not flow to the laser diode driving circuit from switches and others. Also, if the laser diode is handled

carelessly, it may be destroyed instantly because electrostatic discharge is easily applied by a human

body. Therefore, be extremely careful about overcurrent and electrostatic discharge.

5. Use for special applications

This product is not designed or manufactured for use in equipment used under circumstances where failure

may pose a risk to life and limb, or result in significant material damage, etc.

Consult your Sony sales representative when investigating use for medical, vehicle, nuclear power control

or other special applications. Also, use the power supply that was designed not to exceed the optical power

output specified at the absolute maximum ratings.

6. Environment-related Substances to be Controlled

No substances classified at Level 1 (immediate ban) of Sony Technical Standard, SS-00259,

“Management regulations for the Environment-related Substances to be Controlled”. The excerpt from

SS-00259 is introduced on following URL.

http://www.sony.net/SonyInfo/procurementinfo/ss00259/

LASER RADIATION

AVOID EYE OR SKIN EXPOSURE TO

DIRECT OR SCATTERED RADIATION

LASER DIODE

LASER DIODE

AVOID EXPOSURE

Laser radiation is

emitted from this

aperture.

This product complies with 21

CFR Part 1040.10 and 1040.11

Sony Corporation

1-7-1 Konan,

Minato-ku, Tokyo

108-0075 Japan

MAXIMUM OUTPUT

OVER 1

W

WAVELENGTH

600 - 950 nm

CLASS IV LASER PRODUCT