AP1250CMP datasheet(3/5 Pages) A-POWER

3 / 5 page

Application Information

Input Capacitor and Layout Consideration

Place the input bypass capacitor as close as

possible to the

AP1250CMP. A low ESR capacitor

larger than 470uF is recommended for the input

capacitor. Use short and wide traces to minimize

parasitic resistance and inductance.

Inappropriate layout may result in large parasitic

inductance

and

cause

undesired

oscillation

between

AP1250CMP and the preceding power

converter.

Consideration while designs the resistance of

voltage divider

Make sure the sinking current capability of

pull-down NMOS if the lower resistance was

chosen so that the voltage on VREFEN is below 0.2V.

In addition, the capacitor and voltage divider form

the lowpass filter. There are two reasons doing this

design; one is for output voltage soft-start while

another is for noise immunity.

Thermal Consideration

AP1250CMP regulators have internal thermal limiting

circuitry designed to protect the device during

overload conditions.For continued operation, do not

exceed maximum operation junction temperature

125℃. The power dissipation definition in device is:

PD = (VIN - VOUT) x IOUT + VIN x IQ

The maximum power dissipation depends on the

thermal resistance of IC package, PCB layout, the

rate of surroundings airflow and temperature

difference between junction to ambient. The

maximum power dissipation can be calculated by

following formula:

PD(MAX) = ( TJ(MAX) -TA ) /ΘJA

Where TJ(MAX) is the maximum operation junction

temperature 125℃, TA is the ambient temperature

and the ΘJA is the junction to ambient thermal

resistance. The junction to ambient thermal

resistance (ΘJA is layout dependent) for

ESOP-8

package (Exposed Pad) is 75℃/W on standard

JEDEC 51-7 (4 layers, 2S2P) thermal test board.

The maximum power dissipation at TA = 25℃ can

be calculated by following formula:

PD(MAX) = (125℃ - 25℃) / 75℃/W = 1.33W

The thermal resistanceΘJA of

ESOP-8 (Exposed

Pad) is determined by the package design and the

PCB design. However, the package design has

been decided. If possible, it's useful to increase

thermal performance by the PCB design. The

thermal resistance can be decreased by adding

copper under the expose pad of

ESOP-8 package.

We have to consider the copper couldn't stretch

infinitely and avoid the tin overflow.

AP1250CMP

Advanced Power

Electronics Corp.

AP1250CMP bảng dữ liệu(PDF) 3 Page - Advanced Power Electronics Corp.

AP1250CMP bảng dữ liệu(HTML) 3 Page - Advanced Power Electronics Corp.

Html Pages

1 2 3 4 5

bảng dữ liệu tải về

Link URL