P2883

ETALDOC 720/9

Page 3 of 4

August 2007

Notes:

1. The 0.1µF capacitor is fitted to block DC. It may be placed, as an alternative, in either leg of the line pair.

2. If desired, the transformer may be reversed so that the split winding is on the equipment side.

3. To effect a 1:2 step up to line, connect as shown in Fig. 2. The ratio between the two halves of the split

winding is exactly 1.00:1.00 by design, and paralleling the windings is thus always acceptable.

CONSTRUCTION

Dimensions shown are in millimetres (inches).

Geometric centres of outline and pin grid

coincide within a tolerance circle of Ø0.6mm.

Recommended PCB hole size Ø0.8mm.

Terminal pins electroplated pure tin (Sn) 5µm

minimum, JESD97 Category = e3.

12

12

6

3

1

4

5

2

LINE

100

0.1µF

Fig 3 Mechanical Specification