Ku-Band

For more detailed information, please refer to the corresponding CPI Technical Description.

Note: Specifications may change without notice as a result of additional data or product refinement.

Please contact CPI before using this information for system design.

MKT 232, ISSUE 7

03/09

PDF

SPECIFICATIONS, TL12UI

Electrical

Frequency

13.75 to 14.50 GHz

TWT Output Power

1.25 kW peak, 625 W average

Flange Output Power (Linear)

Optimized for IM3 = -26 dBc at

540 W output power (with linearizer),

or IM3 = -26 dBc at 215 W output

power (without linearizer)

Flange Output Power (max)

540W

Bandwidth

750 MHz

Gain

70 dB min. at 540 W output power

70 dB min. at 50 W output power

RF Level Adjust

0 to 30 dB continuous

Output Power Adjustability

±0.1 dB

Gain Stability

±0.25 dB/24 hr max.

(at constant drive and temp.)

Small Signal Gain Slope

±0.02 dB/MHz max.

Small Signal Gain Variation

0.5 dB pk-pk max. over any 80 MHz;

1.0 dB pk-pk max. over any 80MHz

with linearizer option;

3.0 dB pk-pk max. across 750 MHz;

4.0 dB pk-pk max. across 750 MHz

with linearizer option;

5.0 dB pk-pk max. across 750 MHz

with BUC option;

6.0 dB pk-pk max. across 750 MHz

with BUC and linearizer options

Input/Output VSWR

1.30:1 max.

Load VSWR

1.5:1 max. for full spec compliance;

any value without damage;

2.0:1 continuous operation

IESS-308/309

phase noise continuous

12 dB below mask

AC fundamentals related

-50 dBc

Sum of spurs

-47 dBc

Noise and Spurious

<-130 dBW/4 kHz, below 12.7 GHz

(below 11.7 GHz w/ 12.75 GHz config.)

<-65 dBW/4 kHz, passband to 18.0 GHz

(<-60 dBW/4 kHz with linearizer)

<-105 dBW/4 KHz, 18.0 to 26.0 GHz

<-125 dBW/4 kHz, 26.0 to 40.0 GHz

AM/PM Conversion

2.0°/dB max. for single carrier at

8 dB OBO (at 3 dB OBO with

optional linearizer

Harmonic Output

-60 dBc

Intermodulation

-26 dBc max. with linearizer at 540 W

(with two equal carriers)

output power (-26 dBc without linearizer

at 215 W output power)

Electrical (continued)

Group Delay

0.01 ns/MHz linear

(in any 80 MHz band)

0.5 ns pk-pk ripple max.

All ratings are ±10%, 47-63 Hz, 5-wire,

3-phase with neutral and ground

200 to 240 VAC (without neutral)

380 to 415 VAC

Power Factor

0.95 min.

Power Consumption

2.6 kVA max. at 540 W output power

(2.3 kVA typ.)

Environmental

Ambient Temperature

-10° to +50°C operating

-20° to +70°C non-operating

Relative Humidity

95% non-condensing

Altitude

Up to 10,000 ft (3000 m) with standard

adiabatic derating of 2°/1000 ft.;

50,000 feet non-operating

Shock and Vibration

Designed for normal transportation

environment per Section 514.4

MIL-STD-810E. Designed to withstand

20g at 11 ms (1/2 sine pulse) in

non-operating condition

Heat Dissipation

2000 W max.

Mechanical

Cooling(TWT)

Forced air with integral blower.

Maximum external pressure loss

allowable: 0.25 inch water gauge.

RF Input Connection

Type N female

RF Output Connection

WR-75G waveguide flange,

grooved, threaded UNF 2B 6-32

RF Power Monitors

Type N female

Dimensions (W x H x D)

19 x 15.75 x 24 in.

(483 x 400 x 610 mm)

Weight

155 lbs. (70.5 kg) max.

1Prime power AC line unbalance not to exceed 3%. Excess imbalance may cause

an increase in residual RF noise (AM, FM and PM). Phase noise increase is typically 2.5 dB / %

imbalance.

2AC current harmonic content: less than 20%, primarily fifth and seventh harmonics. Harmonics

must be considered when choosing UPS sources.

OPTIONS &

COMP ANION

PRODUCTS:

• Integral Linearizer

• Remote Control Panel

• Redundant and Power

Combined Subsystems

• External Receive Band

Reject Filter

• Integral L-Band Block

Upconverter (BUC)

• Extended Frequency

(12.75 to 14.50 GHz)

Certificate Number: 30515