Soft-Start Power Up

V

I

PTH08T240F

2

3

C

I

4

GND

+

GND

V

I

Track

10

UDG-07128

T − Time − 4 ms/div

(2 A/div)

(1 V/div)

(2 V/div)

PTH08T240F

The Auto-Track feature allows the power-up of multiple PTH/PTV modules to be directly controlled from the

Track pin. However in a stand-alone configuration, or when the Auto-Track feature is not being used, the Track

When the Track pin is connected to the input voltage the Auto-Track function is permanently disengaged. This

allows the module to power up entirely under the control of its internal soft-start circuitry. When power up is

under soft-start control, the output voltage rises to the set-point at a quicker and more linear rate.

From the moment a valid input voltage is applied, the soft-start control introduces a short time delay (typically

between 5 ms and 15 ms) before allowing the output voltage to rise.

Figure 25. Defeating the Auto-Track Function

Figure 26. Power-Up Waveform

The output then progressively rises to the module’s setpoint voltage. Figure 26 shows the soft-start power-up

characteristic of the PTH08T240F operating from a 5-V input bus and configured for a 1.1-V output. The

waveforms were measured with a 10-A constant current load and the Auto-Track feature disabled. The initial rise

in input current when the input voltage first starts to rise is the charge current drawn by the input capacitors.

Power-up is complete within 30 ms.

22

Submit Documentation Feedback

Copyright © 2006–2008, Texas Instruments Incorporated

Product Folder Link(s): PTH08T240F