ATAM893-D datasheet(13/98 Pages) ATMEL

13 / 98 page

4680C–4BMCU–01/05

ATAM893-D

Figure 4-8.

Brown-out Detection

4.3.2

Watchdog Reset

The watchdog's function can be enabled at the WDC register and triggers a reset with every

watchdog counter overflow. To suppress the watchdog reset, the watchdog counter must be

regularly reset by reading the watchdog register address (CWD). The CPU reacts in exactly the

same manner as a reset stimulus from any of the above sources.

4.3.3

External Clock Supervisor

The external input clock supervisor function can be enabled if the external input clock is selected

within the CM and SC registers of the clock module. The CPU reacts in exactly the same man-

ner as a reset stimulus from any of the above sources.

4.4

Voltage Monitor

The voltage monitor consists of a comparator with an internal voltage reference. It is used to

supervise the supply voltage or an external voltage at the VMI pin. The comparator for the sup-

ply voltage has three internal programmable thresholds: one lower threshold (2.2 V), one middle

threshold (2.6 V) and one higher threshold (3.0 V). For external voltages at the VMI pin, the

comparator threshold is set to V

BG = 1.3 V. The VMS bit indicates if the supervised voltage is

below (VMS = 0) or above (VMS = 1) this threshold. An interrupt can be generated when the

VMS bit is set or reset to detect a rising or falling slope. A voltage monitor interrupt (INT7) is

enabled when the interrupt mask bit (VIM) is reset in the VMC register.

CPU

Reset

BOT = 1

2.0 V

1.7 V

CPU

Reset

BOT = 0

d = 1.5 ms (typically)

BOT = 1, low brown-out voltage threshold 1.7 V (is reset value).

BOT = 0, high brown-out voltage threshold 2.0 V.

ATAM893-D bảng dữ liệu(PDF) 13 Page - ATMEL Corporation