CS4364 datasheet(30/50 Pages) CIRRUS

30 / 50 page

DS619F1

CS4364

4.14.2.2 I²C Read

To read from the device, follow the procedure below while adhering to the control port Switching Specifica-

tions.

Initiate a START condition to the I²C bus followed by the address byte. The upper 6 bits must be

001100. The seventh bit must match the setting of the AD0 pin, and the eighth must be 1. The eighth

bit of the address byte is the R/W bit.

After transmitting an acknowledge (ACK), the device will then transmit the contents of the register

pointed to by the MAP. The MAP register will contain the address of the last register written to the

MAP, or the default address (see Section 4.14.1) if an I²C read is the first operation performed on the

device.

Once the device has transmitted the contents of the register pointed to by the MAP, issue an ACK.

If the INCR bit is set to 1, the device will continue to transmit the contents of successive registers. Con-

tinue providing a clock and issue an ACK after each byte until all the desired registers are read, then

initiate a STOP condition to the bus.

If the INCR bit is set to 0 and further I²C reads from other registers are desired, it is necessary to initiate

a repeated START condition and follow the procedure detailed from steps 1 and 2 from the I²C Write

instructions followed by step 1 of the I²C Read section. If no further reads from other registers are de-

sired, initiate a STOP condition to the bus.

4.14.3

SPI Mode

In SPI Mode, data is clocked into the serial control data line, CDIN, by the serial control port clock, CCLK

(see Figure 23 for the clock to data relationship). There is no AD0 pin. Pin CS is the chip select signal and

is used to control SPI writes to the control port. When the device detects a high to low transition on the

AD0/CS pin after power-up, SPI Mode will be selected. All signals are inputs and data is clocked in on the

rising edge of CCLK.

4.14.3.1 SPI Write

To write to the device, follow the procedure below while adhering to the control port Switching Specifica-

tions in Section 2.

Bring CS low.

The address byte on the CDIN pin must then be 00110000.

Write to the memory address pointer, MAP. This byte points to the register to be written.

Write the desired data to the register pointed to by the MAP.

If the INCR bit (see Section 4.14.1) is set to 1, repeat the previous step until all the desired registers

are written, then bring CS high.

SD A

SC L

0011 00

ADD R

AD 0

R/W

Sta rt

ACK

DAT A

1-8

AC K

DA T A

1-8

ACK

Stop

N o te : If o pe ra tion is a w rite , th is b y te c on ta in s the M e m o ry A ddre s s P o inter, M A P .

No te 1

Figure 22. Control Port Timing, I²C Mode

CS4364 bảng dữ liệu(PDF) 30 Page - Cirrus Logic

CS4364 bảng dữ liệu(HTML) 30 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

bảng dữ liệu tải về

Link URL