ADE5169 datasheet(72/148 Pages) AD

72 / 148 page

ADE5166/ADE5169

Rev. 0 | Page 72 of 148

External Voltage ADC in the PSM1 and PSM2 Modes

An external voltage conversion is initiated only by certain actions

that depend on the operating mode of the ADE5166/ ADE5169.

•

In PSM0 operating mode, the 8052 is active. External

voltage measurements are available in the background

measurement mode and by initiating a single measurement.

•

In PSM1 operating mode, the 8052 is active and the part is

powered from battery. Single external voltage measurements

can be initiated by setting the VDCIN_ADC_GO bit (Bit 2) in

the start ADC measurement SFR (ADCGO, Address 0xD8).

Background external voltage measurements are not available.

•

In PSM2 operating mode, the 8052 is not active. External

voltage conversions are available through the background

measurement mode only.

The external voltage ADC in the VDCIN ADC value SFR

(VDCINADC, Address 0xEF) is updated with a new value only

when an external voltage ADC interrupt occurs.

External Voltage ADC Interrupt

The external voltage ADC can generate an ADC interrupt when

at least one of the following conditions occurs:

•

The difference between the new external voltage ADC

value and the last external voltage ADC value generating

an ADC interrupt is larger than the value set in the

VDCIN_DIFF[2:0] bits in the temperature and supply

delta SFR (DIFFPROG, Address 0xF3).

•

The external voltage ADC conversion, initiated by setting

VDCIN_ADC_GO in the start ADC measurement SFR

(ADCGO, Address 0xD8), finishes.

When the ADC interrupt occurs, a new value is available in the

VDCIN ADC value SFR (VDCINADC, Address 0xEF). Note that

there is no flag associated with this interrupt.

ADE5169 bảng dữ liệu(PDF) 72 Page - Analog Devices