| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/20103 bảng dữ liệu(PDF) 433 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/20103 bảng dữ liệu(HTML) 433 Page - Renesas Technology Corp |
|
433 / 992 page ![]() Section 13 Timer RA Rev. 1.00 Oct. 03, 2008 Page 407 of 962 REJ09B0465-0100 13.3 Operation 13.3.1 Operations Common to Various Modes (1) Starting and Stopping Operation Writing the value 1 to the TSTART bit in TRACR starts counting in a set operating mode; writing the value 0 to the TSTART bit stops the counting. The prescaler counts down in the counter clock cycle to be input into the prescaler. The timer counts down using the underflow of the prescaler as a count source. (2) Forced Termination of Operation Writing 1 to the TSTOP bit in TRACR stops the counting forcibly. When the counting is stopped, the timer counter, the prescaler counter, and any associated flags are initialized while the reload registers of the prescaler and the timer counter are retained. (3) Interrupt Request An interrupt request is generated on the underflow of the timer RA counter. (4) Reading and Writing Count Value Reading registers TRAPRE and TRATR reads count values from each register. If a write is performed to TRAPRE or TRATR when the counting is stopped, a specified value is written to both the reload register and the counter. If a write is performed to the TRAPRE register during counting, first a set value is written to the reload register in synchronization with the count source after four cycles of count source, and the set value is then transferred to the prescaler counter in synchronization with the next count source. If a write is performed to the TRATR register, a set value is written to the reload register in synchronization with the underflow of the prescaler, and the set value is transferred to the timer counter in synchronization the next underflow of the prescaler. For this reason, if a write is performed to TRAPRE or TRATR during counting, the value of the counter is not updated immediately after the execution of the write command. Figure 13.2 shows an example operation where a count value is rewritten when the timer RA is counting. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |