| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2117R bảng dữ liệu(PDF) 133 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2117R bảng dữ liệu(HTML) 133 Page - Renesas Technology Corp |
|
133 / 1024 page ![]() Section 5 Interrupt Controller Rev. 1.00 Apr. 28, 2008 Page 107 of 994 REJ09B0452-0100 When using the IRQ6 pin as the IRQ6 interrupt input pin, the KMIMR6 bit must be cleared to 0. When using the IRQ7 pin as the IRQ7 interrupt input pin, the KMIMR15 to KMIMR8 bits must all be set to 1. If even one of these bits is cleared to 0, the IRQ7 interrupt input from the IRQ7 pin is ignored. • Extended vector mode (EIVS = 1 in SYSCR3) Interrupts KIN15 to KIN8 and KIN7 to KIN0, each form a group. The interrupt exception handling for an interrupt request from the same group is started at the same vector address. Interrupt requests are generated on the falling edge of pins KIN15 to KIN0. Interrupt requests KIN15 to KIN0 can be masked by using KMIMRA and KMIMR. The status of interrupt requests KIN15 to KIN0 are not indicated. An IRQ6 interrupt is enabled only by input to the ExIRQ6 pin. The IRQ6 pin is only available for a KIN interrupt input, and functions as the KIN6 pin. The initial value of the KMIMR6 bit is 1. For the IRQ7 interrupt, either the IRQ7 pin or ExIRQ7 pin can be selected as the input pin using the ISS7 bit. The IRQ7 interrupt is not affected by the settings of bits KMIMR15 to KMIMR8. The detection of interrupts KIN15 to KIN0 does not depend on whether the relevant pin has been set for input or output. Therefore, when a pin is used as an external interrupt input pin, clear the DDR bit of the corresponding port to 0 so it is not used as an I/O pin for another function. (4) WUE15 to WUE8 Interrupts Interrupt requests WUE15 to WUE8 can be configured regardless of the setting of the EIVS bit in system control register 3 (SYSCR3). A block diagram of interrupts WUE15 to WUE8 is shown in figure 5.5. S R Q WUEMRn WUEn input WUEn interrupt request Clear signal Rising/falling-edge selection and interrupt enable/disable circuit n = 15 to 8 Figure 5.5 Block Diagram of Interrupts WUE15 to WUE8 |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |