HD6432351 datasheet(285/1025 Pages) RENESAS

285 / 1025 page

Section 7 DMA Controller (DMAC)

Rev. 3.00 Sep 15, 2006 page 251 of 988

REJ09B0330-0300

For setting details, see section 7.3.4, DMA Controller Register (DMACR).

Figure 7.12 shows an example of the setting procedure for normal mode.

Normal mode setting

Set DMABCRH

Set transfer source and

transfer destination

addresses

Set number of transfers

Set DMACR

Read DMABCRL

Set DMABCRL

Normal mode

[1]

[2]

[3]

[4]

[5]

[6]

[1] Set each bit in DMABCRH.

• Set the FAE bit to 1 to select full address

mode.

• Specify enabling or disabling of internal

interrupt clearing with the DTA bit.

[2] Set the transfer source address in MARA, and

the transfer destination address in MARB.

[3] Set the number of transfers in ETCRA.

[4] Set each bit in DMACRA and DMACRB.

• Set the transfer data size with the DTSZ bit.

• Specify whether MARA is to be incremented,

decremented, or fixed, with the SAID and

SAIDE bits.

• Clear the BLKE bit to 0 to select normal

mode.

• Specify whether MARB is to be incremented,

decremented, or fixed, with the DAID and

DAIDE bits.

• Select the activation source with bits DTF3 to

DTF0.

[5] Read DTE = 0 and DTME = 0 in DMABCRL.

[6] Set each bit in DMABCRL.

• Specify enabling or disabling of transfer end

interrupts with the DTIE bit.

• Set both the DTME bit and the DTE bit to 1 to

enable transfer.

Figure 7.12 Example of Normal Mode Setting Procedure

HD6432351 bảng dữ liệu(PDF) 285 Page - Renesas Technology Corp

HD6432351 bảng dữ liệu(HTML) 285 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL