| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
HD6432351 bảng dữ liệu(PDF) 95 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
HD6432351 bảng dữ liệu(HTML) 95 Page - Renesas Technology Corp |
|
95 / 1025 page ![]() Section 2 CPU Rev. 3.00 Sep 15, 2006 page 61 of 988 REJ09B0330-0300 2.8.3 Exception-Handling State The exception-handling state is a transient state that occurs when the CPU alters the normal processing flow due to a reset, interrupt, or trap instruction. The CPU fetches a start address (vector) from the exception vector table and branches to that address. (1) Types of Exception Handling and Their Priority Exception handling is performed for traces, resets, interrupts, and trap instructions. Table 2.7 indicates the types of exception handling and their priority. Trap instruction exception handling is always accepted, in the program execution state. Exception handling and the stack structure depend on the interrupt control mode set in SYSCR. Table 2.7 Exception Handling Types and Priority Priority Type of Exception Detection Timing Start of Exception Handling High Reset Synchronized with clock Exception handling starts immediately after a low-to-high transition at the RES pin, or when the watchdog timer overflows. Trace End of instruction execution or end of exception-handling sequence* 1 When the trace (T) bit is set to 1, the trace starts at the end of the current instruction or current exception-handling sequence Interrupt End of instruction execution or end of exception-handling sequence* 2 When an interrupt is requested, exception handling starts at the end of the current instruction or current exception-handling sequence Low Trap instruction When TRAPA instruction is executed Exception handling starts when a trap (TRAPA) instruction is executed* 3 Notes: 1. Traces are enabled only in interrupt control mode 2. Trace exception-handling is not executed at the end of the RTE instruction. 2. Interrupts are not detected at the end of the ANDC, ORC, XORC, and LDC instructions, or immediately after reset exception handling. 3. Trap instruction exception handling is always accepted, in the program execution state. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |