M52957AFP

Rev.1.0, Sep.19.2003, page 6 of 13

• *1 : Set up the logic control terminal, correspond to the parameter.

• *2 : Change ratio between the first integration current and the second integration current at a voltage of CINT that

is {CINT reference voltage(VCINT)-0.1V} and 1V.

The first integration current (CINT=1V)

The first integration current (CINT=VCINT-0.1V)

) X 100%

The second integration current (CINT=1V)

The second integration current (CINT=VCINT-0.1V)

) X 100%

• *3 : Connect the resistance of 120ΚΩ instead of PSD and establish current output from PHOTO COUPLER

correspond to the parameter. And input the varied resistance ratio. And measure the pulse width of SOUT output at

that time, obtain AFslope and AF linearity from the equations below.

D(9 : 1) • • • The pulse width of SOUT output at input with I1:I2=9:1

D(6 : 4) • • • The pulse width of SOUT output at input with I1:I2=6:4

D(3 : 7) • • • The pulse width of SOUT output at input with I1:I2=3:7

AF slope : DAF = D(9 : 1) - D(7 : 3)

AF linearity : L(AF) = (D(9 : 1) - D(6 : 4)) / (D(6 : 4) - D(7 : 3))

PSD quite resistance : 120K

Ω

• *4 : The input current of one side channel when stationary light remove circuit and I/V transform AMP is not

saturated.