| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
M38B74FD bảng dữ liệu(PDF) 21 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
M38B74FD bảng dữ liệu(HTML) 21 Page - Renesas Technology Corp |
|
21 / 110 page ![]() 38B7 Group SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER MITSUBISHI MICROCOMPUTERS 20 INTERRUPTS Interrupts occur by twenty two sources: five external, sixteen inter- nal, and one software. Interrupt Control Each interrupt except the BRK instruction interrupt has both an inter- rupt request bit and an interrupt enable bit, and is controlled by the interrupt disable flag. An interrupt occurs if the corresponding inter- rupt request and enable bits are “1” and the interrupt disable flag is “0.” Interrupt enable bits can be set or cleared by software. Interrupt request bits can be cleared by software, but cannot be set by soft- ware. The BRK instruction interrupt and reset cannot be disabled with any flag or bit. The I flag disables all interrupts except the BRK instruction interrupt and reset. If several interrupts requests occur at the same time, the interrupt with highest priority is accepted first. Interrupt Operation Upon acceptance of an interrupt the following operations are auto- matically performed: 1. The contents of the program counter and processor status register are automatically pushed onto the stack. 2. The interrupt disable flag is set and the corresponding interrupt request bit is cleared. 3. The interrupt jump destination address is read from the vector table into the program counter. Interrupt Source Selection Any of the following interrupt sources can be selected by the inter- rupt source switch register (address 003916). 1. INT1 or Serial I/O3 2. INT3 or Serial I/O2 transmit 3. INT4 or A-D conversion sNote When the active edge of an external interrupt (INT0–INT4) is set or when switching interrupt sources in the same vector address, the corresponding interrupt request bit may also be set. Therefore, please take following sequence: (1) Disable the external interrupt which is selected. (2) Change the active edge in interrupt edge selection register (3) Clear the set interrupt request bit to “0.” (4) Enable the external interrupt which is selected. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |