M34286G2GP datasheet(23/66 Pages) RENESAS

23 / 66 page

Rev.1.00

Aug 06, 2008

page 23 of 64

REJ03B0251-0100

4286 Group

LIST OF PRECAUTIONS

➀ Noise and latch-up prevention

Connect a capacitor on the following condition to prevent noise

and latch-up;

•

connect a bypass capacitor (approx. 0.01 µF) between pins

VDD and VSS at the shortest distance,

•

equalize its wiring in width and length, and

•

use the thickest wire.

•

Port E2 is also used as VPP pin. Connect this pin to VSS

through the resistor about 5kΩ which is assigned to E2/VPP

pin as close as possible at the shortest distance.

➁ Register initial values 1

The initial value of the following registers are undefined after

system is released from reset. After system is released from

reset, set initial values.

• Register D (3 bits)

• Register E (8 bits)

➂ Register initial values 2

The initial value of the following registers are undefined at RAM

backup. After system is returned from RAM back-up, set initial

values.

• Register X (4 bits)

• Register Y (4 bits)

• Register D (3 bits)

• Register E (8 bits)

➃ Stack registers (SKS)

Stack registers (SKs) are four identical registers, so that

subroutines can be nested up to 4 levels. However, one of

stack registers is used when executing a table reference

instruction. Accordingly, be careful not to over the stack. The

contnts of registers SKs are destroyed when 4 levels are

exceeded.

➄ Notes on unused pins

➅ Timer

•

Count source

Stop timer 1 or timer 2 counting to change its count source.

•

Reading the count value

Stop timer 1 or 2 counting and then execute the data read

instruction (TAB1, TAB2) to read its data.

•

Watchdog timer

Be sure that the timing to execute the WRST instruction in

order to operate WDT efficiently.

•Writing to reload register R1

When writing data to reload register R1 while timer 1 is

operating, avoid a timing when timer 1 underflows.

•

Timer 1 count operation

When the bit 5 of the watchdog timer (WDT) is selected as

the timer 1 count source, the error of maximum ± 64 µs (at

the minimum instruction execution time : 2 µs) is generated

from timer 1 start until timer 1 underflow. When

programming, be careful about this error.

•

Stop of timer 2

Avoid a timing when timer 2 underflows to stop timer 2.

•

Writing to reload register R2H

When writing data to reload register R2H while timer 2 is

operating, avoid a timing when timer underflows.

•

Timer 2 carrier wave output function

When to expand “H” interval of carrier wave is valid, set “1”

or more to reload register R2H.

•

Timer 1 and timer 2 carrier wave output function

Count starts from the rising edge ➁ in Fig. 29 after the first

falling edge of the count source, after timer 1 and timer 2

operations start ① in Fig. 29.

Time to first underflow ③ in Fig. 29 is different from time

among next underflow ④ in Fig. 29 by the timing to start the

timer and count source operations after count starts.

D0–D7

E0, E1

G0–G3

CARR

Connection

Open (Set the output latch to “1” ).

Open (Set the output latch to “0” ).

Connect to VDD.

Open (Set the output latch to “1” ).

Open (Set the output latch to “0” ).

Connect to VDD.

Open.

Connect to VSS.

Open (Set the output latch to “1” ).

Open (Set the output latch to “0” ).

Connect to VDD.

Open.

Usage condition

Pull-down transistor OFF.

(Note when connecting to VSS and VDD)

•

Connect the unused pins to VSS and VDD at the shortest

distance and use the thick wire against noise.

Fig. 29 Count start time and count time when operation

starts (T1, T2)

032

103

➀

➃

➂

➁

Timer start

Count source

Timer value

Timer underflow signal

➆ Program counter

Make sure that the program counter does not specify after the

last page of the built-in ROM.

M34286G2GP bảng dữ liệu(PDF) 23 Page - Renesas Technology Corp

M34286G2GP bảng dữ liệu(HTML) 23 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

bảng dữ liệu tải về

Link URL